The Testing Blog

The ANSI C63.10, a standard for Testing Unlicensed Wireless Devices by the American Standards Institute (ANSI) and Accredited Standards Committee (ASC) C63® was published by the Institute of Electrical and Electronics Engineers (IEEE) on Sept. 10, 2009. This new standard has in one document, procedures for testing many unlicensed wireless devices for compliance with the Rules and Regulations of the Federal Communications Commission (FCC). Previously this information and testing procedures were scattered in various FCC rules, the FCC Knowledge database, ANSI C63.4 and various other FCC and IC publications. The FCC accepted the use of this new standard on November 25, 20090 (refer to FCC DA No. 09-2478) as an alternative to ANSI C63.4:2003.

Interference Technology recently invited a panel of experts, who were also a part of the working group on the standard, to weigh in on the implications ad the effects of the standard on testing and day to day lab operations. This group and panel included Mark Briggs, Principal Engineer at Elliott Labs, NTS Silicon Valley division. Click here to review the full article and panel discussion.

The FCC has announced that it has currently halted issuing new and any Class 2 Permissive Change certifications that require a DFS evaluation for Master devices until further notice. The National Telecommunications and Information Administration (NTIA) is currently investigating interference with UNII Master Devices and the FCC. Dynamic Frequency Selection (DFS), a mechanism to allow unlicensed devices to share spectrum with existing radar systems is mandated in the 5250-5350 and 5470-5725 MHz UNII bands.

Elliott Laboratories continues to test Master devices and is currently awaiting on further updates from the FCC. For more information, please contact us via email at info@elliottlabs.com or at 408-245-7800.

The Federal Communications Commission (FCC) issued a $7,000 forfeiture against Sennheiser Electronic Corporation for willful and repeated violation of Section 302(b) of the Communications Act of 1934; the apparent violation involves Sennheiser’s marketing of unauthorized radio frequency devices.

In July 2008, the Enforcement Bureau Spectrum Enforcement Division began an investigation into Sennheiser’s marketing of wireless microphones. In a letter of inquiry dated August 15, 2008, the Division instructed Sennheiser to provide specific information regarding the manufacture, marketing, and the certification status of the wireless microphone systems it sells. In its September 15, 2008, response to the letter of inquiry, Sennheiser indicates that, while preparing its response, it discovered that one of its wireless microphones did not have a valid certification.

Readers can view the FCC notice by clicking here.

Manufacturers of Information Technology Equipment (ITE) intended for sale in the European Union should take note of some important changes that are slated to go into effect with regard to their EMC testing requirements under emissions standard EN 55022:2006.

In November 2008 the European Union’s Official Journal (OJ) published lists of standards for the Electromagnetic Compatibility (EMC) Directive and Radio and Telecommunications Terminal Equipment Directive (R&TTED). Both lists include references to EN 55022:2006 and its amendment A1, released in 2007.

EN 55022:2006 will supersede EN 55022;1998 and become the requirement for Information Technology Equipment (ITE) sold into the European Union after October 1st 20091 , with the requirements of Amendment A1:2007 coming into force one year later on October 1st 2010. What are the differences between the 1998 and 2006 versions of the standard and what new requirements will be introduced by A1:2007? Let’s begin by reviewing the history of CISPR 22 from 1997 onwards. International Standard CISPR 22 is the basis for not only EN 55022 but also for many of the other national versions of standards for ITE.

To read the rest of the article, please click here.

Elliott Laboratories is currently equipped to conduct the EU free space testing above 1 GHz per EN55022:2006+ A1 and/or CISPR 22:2005 + A1 in all chambers at our Fremont facility. For more information about how this change affects your products or for a price quote to test your product, please contact us at info@elliottlabs.com or call at 408-245-7800.